Fujitsu ETERNUS DX200 S3 Configuration Manual page 104

Chapter 6 Monitoring Settings
6.2 Various Notification Settings
(5)
Click the [OK] button.
The SNMP Agent basic settings are applied.
(6)
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
3
Set up the SNMP Manager.
Set up the SNMP Manager (monitoring server) that is the destination of the SNMP Trap transmission.
This step is not required when ETERNUS SF Storage Cruiser is used to monitor the ETERNUS DX Disk
storage system.
(1)
In [Action], click [Setup SNMP Manager].
The [Setup SNMP Manager] screen appears.
(2)
In the manager list of the [Setup SNMP Manager] screen, click the [Add] button.
The [Manager] screen appears.
(3)
Enter the IP address of SNMP Manager (monitoring server) and click the [OK] button.
The screen display returns to the manager list of the [Setup SNMP Manager] screen.
(4)
Check the SNMP Manager that was added in
[Set] button.
A confirmation screen appears.
(5)
Click the [OK] button.
The SNMP Manager settings are applied.
(6)
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Step (3)
104
Copyright 2014 FUJITSU LIMITED
is displayed in the manager list and click the
P3AM-7652-02ENZ0