Preparing The Pc Terminal For Setup - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 3 Checking the Configuration Environment
3.3

Preparing the PC Terminal for Setup

6
Shut down the server.
After this, the settings for the ETERNUS DX Disk storage system must be completed before connect-
ing the ETERNUS DX Disk storage system to the server. In order to perform these settings, turn off the
server.
3.3 Preparing the PC Terminal for Setup
The initial settings are performed by using a Web browser on the PC terminal.
Prepare and set up the PC terminal before the initial settings.
Preparing the PC terminal
Prepare the PC terminal that contains the following environment:
Web browser
•
Usable Web browsers are shown below. Using Web browsers other than the following is possible, but prop-
er operation is not guaranteed.
Microsoft Internet Explorer 7.0, 8.0, 9.0, 10.0 (desktop version), 11.0 (desktop version)
-
Mozilla Firefox 3.6.x, ESR 10.0.x, ESR 17.0.x, ESR 24.0.x
-
Setting up the PC terminal
Set up the PC terminal with the following procedure:
1
Set the IP address and subnet mask of the PC terminal.
Set the following values.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
2
Check the settings of the Web browser.
For details on the required settings, refer to "Configuration Guide (Web GUI)".
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
50
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0