Fujitsu ETERNUS DX200 S3 Configuration Manual page 61

Chapter 4 Connecting Cables
4.2 Drive Enclosure Connection
Connect the cable in the same way as
Drive enclosure 2
Drive enclosure 1
3
When two controllers are installed, connect Controller 1 next.
(1)
Connect the controller enclosure to the drive enclosure.
Connect the DI (IN) port of I/O module 1 (IOM#1) in drive enclosure 2 to the DI (OUT) port of Con-
troller 1 (CM#1) with the cable between enclosures.
(i)
(ii)
Drive enclosure 2
Drive enclosure 1
Controller enclosure
(2)
Connect between the drive enclosures.
Connect the DI (OUT) port of I/O module 1 (IOM#1) in drive enclosure 2 to the DI (IN) port of I/O
module 1 (IOM#1) in drive enclosure 1 with the cable between enclosures.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Connect the plug to be connected to DI (OUT) port, to the DI (OUT) port of the Controller 1
(CM#1) in the controller enclosure.
Connect the plug to be connected to the DI (IN) port, to the DI (IN) port of the I/O module 1
(IOM#1) in drive enclosure 2.
Copyright 2014 FUJITSU LIMITED
Step (1).
61
P3AM-7652-02ENZ0