Firewall Settings - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 5 General Settings
5.6

Firewall Settings

5.6 Firewall Settings
Set the firewall for each service. The settings are required respectively for the MNT port and the RMT port.
If both HTTP connection and HTTPS connection are disabled, the device is inaccessible via ETERNUS Web
•
GUI.
If both Telnet connection and SSH connection are disabled, the device is inaccessible via ETERNUS CLI.
•
Some functions cannot be used if the ETERNUS DX Discovery function is enabled for the MNT port. Make
•
sure to disable the ETERNUS DX Discovery function in "Firewall Setting".
1
Start the Web browser and log in to ETERNUS Web GUI with the IP address that is set in
"5.4 Storage Management (Initial Setup 1)" (page
2
Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
3
In [Category], click [Network].
The [Network] screen appears.
4
Select the port to be set. In [Action], click [Firewall Setting].
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
77).
86
Copyright 2014 FUJITSU LIMITED
Step 7 in
P3AM-7652-02ENZ0