Fujitsu ETERNUS DX200 S3 Configuration Manual page 57

Chapter 4 Connecting Cables
4.2 Drive Enclosure Connection
The following procedure explains how to connect the cable between enclosures.
• To help with management of the cable between enclosures and prevent incorrect connections, make
sure to attach the destination labels to the connectors of the cables.
• When connecting the cable between enclosures, check the direction of the connector and insert it all the
way in firmly.
To disconnect the mini SAS HD cables between enclosures, hold the tab and then pull out the connector.
When high-density drive enclosures are installed, fasten the high-density drive enclosure cable between
enclosures with the clamp belts to the flap brackets and the cable management arm on the rear of the
device.
Cable management arm
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Pull-tab
Clamp belts
Flap bracket
Clamp belts
57
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0