Fujitsu ETERNUS DX200 S3 Configuration Manual page 173

Chapter 10 System Status Check
10.6 Powering Off
After power-off, wait for about one minute before turning power on again.
•
If the Power switch is pressed again between the time of the READY LED (
•
POWER LED (
2
The ETERNUS DX Disk storage system power is turned off.
The POWER LED ( ) of the controller enclosure and the POWER LEDs (
turned off.
■
When a Power Synchronized Unit is Used
If the server is turned off, the ETERNUS DX Disk storage system is also turned off.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
) turning off, the ETERNUS DX Disk storage system power may turn on.
173
Copyright 2014 FUJITSU LIMITED
) turning off and the
) of the drive enclosures are
P3AM-7652-02ENZ0