Fujitsu ETERNUS DX200 S3 Configuration Manual page 36

Chapter 2 Rack Installation
2.3 2.5" / 3.5" Type Drive Enclosure Installation (for Regions Other than EMEA&I)
2
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the four washers to fasten the
rack rails to the rear rack pillars.
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any space
between them.
Plate
M5 screw
(Rack pillar: front)
The M5 screw positions for the rack rails are determined by the drive enclosure base line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the
2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
Sixth screw
(M5 screw)
First screw
(M5 screw)
Fifth screw
(M5 screw)
Second screw
(M5 screw)
3
Tighten the M4 screws of the rack rails that were slightly unscrewed in
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Rack rail (left)
Plate
M5 screw
Front view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Rear view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Copyright 2014 FUJITSU LIMITED
M5 screw
Washer
(Rack pillar: rear)
Rack rail (right)
[Right]
Sixth screw
(M5 screw)
First screw
(M5 screw)
[Right]
Fifth screw
(M5 screw)
Second screw
(M5 screw)
36
M5 screw
Washer
Step 1.
P3AM-7652-02ENZ0