Syslog Setup - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 6 Monitoring Settings
6.2 Various Notification Settings
11
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
6.2.3

Syslog Setup

If an event occurs in the ETERNUS DX, logs for the event can be sent to the specified Syslog server (external
server).
Up to two Syslog servers can be set.
•
• Make sure to check whether the Syslog server receives logs correctly after the Syslog notification envi-
ronment setup is complete.
• Logs are not sent again when a communication error occurs between the ETERNUS DX and the Syslog
server.
The Syslog setting is explained below.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Network].
The [Network] screen appears.
3
In [Action], click [Setup Syslog].
The [Setup Syslog] screen appears.
4
In the [Setup Syslog] screen, set the required items.
Select "on(RFC3164)" or "on(RFC5424)" for "Send Log".
•
To send messages in RFC5424 format to a target Syslog server that supports RFC5424, select
"on(RFC5424)". If this is not the case, select "on(RFC3164)".
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
91
P3AM-9002-01ENZ0