Connection Setup For Power Synchronized Unit; Wake On Lan Settings - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 7 Power Control Setup
7.2

Connection Setup for Power Synchronized Unit

7.2 Connection Setup for Power Synchronized Unit
Refer to "Configuration Guide (Power Synchronized Unit)" for the required settings to use power control by
connecting power synchronized units to an ETERNUS DX Disk storage system.
7.3

Wake On LAN Settings

A network environment needs to be set to receive magic packets that are used by Wake On LAN for the ETER-
NUS DX Disk storage system.
The procedure to set Wake On LAN is as follows.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Network].
The [Network] screen appears.
3
In [Action], click [Setup Network Environment].
The [Setup Network Environment] screen appears.
4
In the [Setup Network Environment] screen, select [Enable] for [Wake On LAN].
For operations with cluster connections, set the IP address of the Slave CM for the "Slave IP Address"
•
of the MNT port.
To control power supply with servers in a network to which the ETERNUS DX Disk storage system does
•
not belong, set "Gateway" and specify the server IP address or the network address in "Allowable IP
Address".
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
123
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0