Configuring Member Devices - 3Com 4200G 12-Port Configuration Manual

Operation
Configure a shared FTP server
for the cluster
Configure a shared TFTP
server for the cluster
Configure a shared logging
host for the cluster
Configure a shared SNMP host
for the cluster
Enabling management VLAN synchronization
By default, VLAN 1 is the management VLAN. To specify another VLAN as the management VLAN for
the cluster, you must configure the same management VLAN on all the devices that are about to join the
cluster.
By enabling the management VLAN synchronization function on the management device, you can
enable the management device to send a management VLAN synchronization packet periodically to
the connected devices. After the devices receive the management VLAN synchronization packet, they
set their own management VLANs according to the packet. In this way, all devices set the same
management VLAN automatically, and thus simplify your configurations.
Follow these steps to enable management VLAN synchronization:
To do...
Enter system view
Enter cluster view
Enable management VLAN
synchronization

Configuring Member Devices

Member device configuration tasks
Table 2-12 Member device configuration tasks
Enabling NDP globally and on specific ports
Enabling NTDP globally and on a specific port
Enabling the cluster function
Accessing the shared FTP/TFTP server from a
member device
ftp-server ip-address
tftp-server ip-address
logging-host ip-address
snmp-host ip-address
Use the command...
system-view
cluster
management-vlan
synchronization enable
Operation
Command
Required
Required
Required
Optional
2-13
Description
Optional
By default, the management
device acts as the shared FTP
server.
Optional
By default, no shared TFTP
server is configured.
Optional
By default, no shared logging
host is configured.
Optional
By default, no shared SNMP
host is configured.
Remarks
—
Required
Required
Disabled by default.
Description