Table of Contents
Advertisement
DMD50 Universal Satellite Modem
F.3
Network Configuration Summary
If the above steps were followed and the information was entered, then the following would be
the TCP / IP configuration summary for a 'no router specified' setup:
1. Boot Mode =
2. Bootp Server Tag =
3. Modem Host=
4. IP Address Mask =
5. Modem IP Address =
6. Server IP Address =
7. Router IP Address =
8. Modem Ethernet Address =
9. Ethernet Rate =
F.4
Ethernet Test
F.4.1 Connecting the Modem Ethernet Cable to a Network Link
1. Connect the Network Switch (Hub) to the Modem Ethernet port (J9) using standard RJ-45
to RJ-45 10BaseT (CAT-5) Cables as shown below.
F.4.2 Connecting the Modem Ethernet Cable Directly to a Computer
(without a Network)
The user can directly connect to the equipment without connecting to a network. This will often
occur at remote sites where a network is not available. To connect, the user will need an Ethernet
Crossover (Null) cable. The pinout for this cable is as follows,
MN-DMD50 Revision 4
Figure F-1. DMD20 Ethernet Network Connection
RJ45 Connector A
Pin #1
Pin #2
Pin #3
Pin #4
Pin #5
Pin #6
Pin #7
Pin #8
NON-VOL
206
DMD20
255.255.0.0
172.18.100.215
172.18.4.250
010.000.001.001
0010650903EB
10 MBPS/HD
RJ45 Connector B
Pin #3
Pin #6
Pin #1
Pin #4
Pin #5
Pin #2
Pin #7
Pin #8
TCP/IP Ethernet Setup
F–3
Advertisement
Table of Contents
