Monitor Menu Options And Parameters - Radyne DMD20 Installation And Operation Manual

User Interfaces
REMOTE AUPC (menu)
AUPC ENABLE
LOOPBACK
TX 2047 PATTERN
REMOTE AUPC MONITOR
REMOTE 2047 BER:

4.3.6 Monitor Menu Options and Parameters

EVENTS
ERASE EVENTS.. PRESS CLEAR
INPUT LEVEL (dBm)
Eb/No (dB)
RAW BER:
CORRECTED BER
4-14
The 'REMOTE AUPC CONFIGURATION' menu contains
the remote configuration parameters for the AUPC
Function.
{OFF, ON}
Allows the user to enable or disable the AUPC Function
of the remote modem. The remote AUPC Function is
the response of the local modem to commands for an
increase or decrease of the Transmit Power in 0.5 dB
steps and the command to change to the setting
indicated in the 'REMOTE CL ACTION' menu of the
remote modem upon receiver loss of lock.
Allows the user to enable or disable the Baseband
Loopback Test Mode of the remote modem.
Allows the user to enable or disable the Transmit 2047
Pattern Test Mode of the remote modem.
The 'REMOTE AUPC MONITOR' Menu contains the
remote monitor status for the AUPC Function.
Reports the BER measurement of the receiver 2047
Pattern Test Mode of the remote modem. BER is
-5
reported from the 1x10
If the pattern does not synchronize or is out of range,
'NO DATA' will be displayed.
Displays a history of events recorded in the event buffer.
A maximum of 40 events may be stored in the buffer.
st
Upon receipt of the 41
automatically deleted, and so on, maintaining the
maximum 40 events.
Clears the contents of the Event Buffer.
Displays the estimated receive signal level as seen by
the Demodulator.
Displays the estimated E
demodulator.
Displays the estimated channel error rate (before
decoding) measured by the modem.
The CBER display shows an estimated corrected bit
error rate of the modem. Depending on the symbol rate
the modem is running, the high-end performance scale
of this display will vary (10 E
symbol rates, a better than scale reading will appear as
-00
0.0 x 10 . At other symbol rates, it will appear as E**. In
either case, they both mean performance is better than
the scale upper limit.
DMD20 Universal Satellite Modem
-7
to 1x10 in tenth decade steps.
event, the first received event is
/N as seen by the
b o
-9 -10 -11
, 10 or 10 ). At some
TM103 - Rev. 1.1