Set Partition Memory_Opration_Mode - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
Moreover, also when values which are the same as the current values are set, power ff/on is not required
and the above-mentioned message is not displayed.

Privilege: Administrator, Operator, Partition Operator (Only managed partition)
(1) Input format
set partition memory_mirror_ras_mode <partition#> [mirror_keep |capacity_keep ] {quiet}
(2) Option
quiet: The command is executed without interactive operation to User.
(3) Usage example
Example: When setting Memory Mirror RAS Mode of the Partition3 to Mirror Keep Mode
# set partition memory_mirror_ras_mode 3 mirror_keep
The setting will become effective the next time the partition power off/on is performed
#
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
The setting will become effective the next time the partition power off/on is performed.
The specified partition number is invalid.
The specified parameter is invalid.
Unable to execute this command on a standby MMB.
Failed to execute %s command.
Failed to execute set partition command.
Unable to change the mode while the partition is running.
Please try to change the mode after the partition is shutdown.
Unable to execute this command because you have not authority to operate this partition.

2.2.28 set partition memory_opration_mode

It sets the Memory Operation Mode of the specified partition.
By default normal (Mode invalid) is set.
performance : sets the Performance Mode
normal
partial_mirror : sets the Partial Mode
full_mirror
spare
For the partition which is already powered ON, when the settings are performed by this command, following
message is displayed and settings cannot be performed.
"Unable to change the mode while the partition is running.
Please try to change the mode after the partition is shutdown."
When the partition is configured of or above 2SB, and when Reserved SB is set, also, when the settings
other than the Memory Operation Mode satisfying the DIMM configuration requirement of SB is set as
Reserved SB, following message is displayed and setting cannot be possible.
"The SB with DIMM that does not satisfy requirements of Mode is
registered as a Reserved SB.
: sets the Normal Mode
: sets the Full Mode
: sets the Spare Mode