Figure 3.23 Display Example Of [Attempt Configuration] Menu; Table 3.29 Display Contents Of Menu Selection - Fujitsu PRIMEQUEST 2000 Series Tool Reference

UEFI Menu Operations
3.4.5.4 [Attempt Configuration] Menu
As for the Attempt xxxx which is selected from
xx:xx:xx:xx:xx:xx which is selected from
Boot can be done in [Attempt Configuration] menu.
The settings which were changed in this menu are enabled after system reset.
The example of window displayed immediately after starting the [Attempt Configuration] menu is shown below.

FIGURE 3.23 Display example of [Attempt Configuration] Menu

(1) Page information display
It is displayed as [Attempt Configuration].
(2) Menu selection
Menu shown in
Item
iSCSI Attempt Name
iSCSI Mode
Internet Protocol
"3.4.9.1 [MAC Selection]
"TABLE 3.29 Display contents of menu

TABLE 3.29 Display contents of menu selection

Sets the name of iSCSI setting.
Types of characters that can be entered are given below.
0-9,A-Z,a-z,!"#$%&'()*+,-./:;<=>?@[ ¥]ˆ_'{|}
Enables/disables the iSCSI boot setting.
・Enabled for MPIO
・Enabled
・Disabled
By default, it is Disabled.
Selects Internet Protocol.
・IP4
・IP6
・Autoconfigure
By default, it is IP4.
Remarks
When it is set to "Autoconfigure", iSCSI boots with IPv4 and when it is
failed, it is attempted to boot iSCSI with IPv6.
"3.4.9 [iSCSI Configuration]
Menu", various settings related to iSCSI
selection" is displayed.
Display contents
menu" or the network port MAC