Update Command; Update All - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.4

Update Command

Update Commands are as follows.

2.4.1 Update ALL

2.4.2 show update_status
This section describes operation procedure of these commands.
2.4.1 Update ALL
The update ALL command batch-downloads firmware from the specified URL and updates the MMB, BMC,
and BIOS with the downloaded firmware.
Specify the URL as follows:
http://host/path/file
ftp://host/path/file
The update sequence is as follows:
(1) MMB firmware update (standby)
(2) MMB firmware update (active)
(3) BMC firmware update
(4) BIOS firmware update
You can check the progress by using the show update_status command.
Note
If the MMB or SB is faulty, perform maintenance on it before updating the firmware. Do not update the
firmware in a configuration with a faulty MMB or SB.

Privilege: Administrator or CE
(1) Input format
update ALL <url> {force} {quiet}
(2) Option
force: This option forcibly updates the firmware based on the applicable general firmware version.
quiet: This option updates the firmware without user interaction.
(3) Usage example
# update ALL http://host/path/allfirm001
Downloading an unified firmware file.........
Extracting an unified firmware file............
Current Unified Firmware Version: xxxxx
New Unified Firmware Version: yyyyy
Are you sure to continue Firmware Update? [Y|N]: Y
#
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
Are you sure to continue Firmware Update? [Y|N]: