Table 1.54 [Mmb#X] Window Button - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB Web-UI (Web User Interface) Operations
Items
Reset MMB
Switch Over to MMB
Enable/Disable MMB
Voltage
Sensor
Voltage
Threshold Warning
(Low/High)
Critical
(Low/High)
Buttons
On Turns on the Location LED when the [On] button is clicked.
Off Turns off the Location LED when the [Off] button is clicked
Apply Click the [Apply] button to set the specified control information.
Cancel Click the [Cancel] button to restore the original information and not set the specified information.
(1) Menu Operation
[System] – [MMB] – [MMB#x]
(2) Window Operations
Confirmation dialogue box is displayed. Specify the information which shows the change in MMB
status, click the [Apply] button. Sets the information which shows the change in MMB status.
[Message]
This section describes the messages to be displayed on this window.
Message Number
I_00013 Setting completed.
I_00052 MMB switch processing has started.
I_00095 The standby MMB is rebooting now. Please wait several minutes.
E_00100 Failed to set the LED
E_00125 Failed to switch over to another MMB.
E_00125 Failed to change Enable/Disable status of the MMB.
E_00125 Failed to reset the MMB.
I_00213 %aa cannot be executed because the system is under maintenance.
I_00467 The reboot is done. Login after a while.
W_00413 Nothing is selected.
On/ Off of the Location LED can be controlled by clicking [On], [Off] buttons.
Resets the MMB if this check box is checked.
When this check box is checked, [Switch Over to MMB] mentioned below cannot
be set.
Switches the Active/Standby of the MMB if this check box is checked.
When this check box is checked, [Reset MMB] mentioned above cannot be set.
Remarks
This check box is displayed only, when two MMBs are mounted.
Controls Enable/ Disable of the MMB.
Because this item is a facility used for testing, it is not possible to usually set it.
Displays the Voltage sensor type.
P3.3VL
P1.5VL
P1.5VL_CPLD
P1.2VL
P1.0VL
P0.75VL
Displays the current power voltage.
Lower and upper limits of the warning-level voltage.
Displays " – ", when the threshold is not set.
Displays the power voltage in the last two decimal places.
Lower and upper limits of the critical-level voltage.
Displays " – ", when the threshold is not set.
Displays the power voltage in the last two decimal places.

TABLE 1.54 [MMB#x] Window button

Description
Description
Message