Fujitsu PRIMEQUEST 2000 Series Tool Reference page 174

MMB Web-UI (Web User Interface) Operations
Cancel Restores the original information and does not set the specified information, such as the date
and time zone.
(1) Menu Operation
[Network Configuration] - [Date/Time]
(2) Window Operations
1. Specify information such as the date and time zone. Then, click the [Apply] button.
This sets the information such as the date and time zone.
[Message]
The following table lists the messages displayed in this window.
Message Number
I_00013 Setting completed.
E_00020 The IP address overlaps.
E_00100 Failed to set Date/Time information
W_00414 Invalid Date Format
W_00434 Invalid Time Format
W_00433 The duplicate IP address was found.
W_00432 Invalid IP Address specified.
For details on the messages displayed on the window, see
(C122-E178EN).
Time synchronization with NTP
This section describes the operational specifications for the NTP client.
- When starting time synchronization:
The NTP client on the MMB synchronizes the time at the start of operation, irrespective of the
time difference with the NTP server.
The NTP client on the MMB starts operation:
- when the NTP services on the MMB are enabled (i.e., when [Enable] in the [NTP] field
is checked and the [Apply] button is clicked in the [Network Configuration] - [Date/Time]
window), or
when the MMB is reset, the MMB redundancy is switched, and the AC power is turned
-
from OFF to ON while the NTP services on the MMB are enabled.
- When starting time synchronization:
The time-adjusting method on the NTP varies depending on the NTP operation mode (Step mode
or Slew mode).
In Step mode, if the time difference between the synchronized NTP servers and the MMB is:
(1) within a range of -0.128 to +0.128 seconds, the NTP executes Slew adjustment, which
corrects the time at a rate of up to 0.0005 per second without reversal.
(2) outside a range of -0.128 to +0.128 seconds and within a range of -1000 to +1000
seconds, the NTP executes Step adjustment. (In this case, the clock may be reversed.)
(3) outside a range of -1000 to +1000 seconds, the NTP function stops.
In Slew mode, if the time difference between the synchronized NTP servers and the MMB is:
(1) within a range of -600 to +600 seconds (10 minutes) , the NTP executes Slew
adjustment, which corrects the time at a rate of up to 0.0005 per second without
reversal.
(2) outside a range of -600 to +600 seconds (10 minutes) and within a range of -1000 to
+1000 seconds (16 minutes and 40 seconds) , the NTP executes Step adjustment. (In
this case, the clock may be reversed.)
(3) outside a range of -1000 to +1000 seconds (16 minutes and 40 seconds) , the NTP
function stops.
- Time synchronization interval
The NTP client synchronizes at an interval of 64 to 1024 seconds. The initial synchronization
interval is 64 seconds. As the synchronization accuracy becomes stable, this interval gradually
doubles from 64 seconds to 128 seconds, then to 256 seconds, then to 512 seconds, and finally
to 1024 seconds.
Message
PRIMEQUEST 2000 Series Message Reference