Table 1.103 Buttons In The [Snmp Community] Window - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB Web-UI (Web User Interface) Operations
Items
IP Address/MASK
SNMP Version
Access
Auth

TABLE 1.103 Buttons in the [SNMP Community] window

Buttons
Apply Sets the specified information.
Cancel Restores the original information and does not set the specified information, such as the
community or the IP address permitted access.
(1) Menu Operation
[Network Configuration] - [SNMP Configuration] - [Community]
(2) Window Operations
- Configuring information such as the community
1. Enter information such as the community, the IP address permitted access, the SNMP version,
the access permission, and the authentication. Then, click the [Apply] button.
This sets the entered information.
Deleting information such as the community
-
1. Delete the community and the IP address permitted access. Then, click the [Apply] button.
This clears the specified information.
[Message]
The following table lists the messages displayed in this window.
Message Number
I_00013 Setting completed.
For details on the messages displayed on the window, see
(C122-E178EN).
[SNMP Trap] window
You can set SNMP trap destinations in the [SNMP Trap] window.
You can set up to 16 trap destinations.

To specify an IP address: Enter the IP address.

To specify a subnet: Enter the subnet and mask.
Sets the SNMP version. (1, 2, 3)
Sets whether to permit only reading or both reading and writing.

Read Only

Read Write
Sets the security level.
You can specify this only if [3] is selected for [SNMP Version].

noauth: Do not use the authentication function.

auth: Use the authentication function.

priv: Use the authentication function and "privacy" function (data encryption).
With [1] or [2] selected for [SNMP Version], this item is grayed out and disabled. In
this case, the only available security level is noauth.
Description
Description
Message
PRIMEQUEST 2000 Series Message Reference