Names And Functions Of Controls - Yaesu FT1DR Operating Manual

Names and Operation of Controls

Names and Functions of Controls

a
b
c
d
e
f
g
h
i
j
a Antenna terminal (SMA)*
b Flashlight (White LED)
• This LED can be used as a small flashlight in a
dark place.
c A-band BUSY/TX lamp
B-band BUSY/TX lamp
These lamps glow green during reception, and
glow red during transmission.
d pPTT switch
• Press and hold the
e Tswitch
• Press and hold the
squelch function.
• While pressing the
O
the knob to adjust the squelch level.
f v switch
While pressing the
adjust the volume level.
g P switch
• Press and hold the
turn on the FT-D1.
• Press and hold the
again to turn off the FT-D1.
P
• Press the
h Akey (switching between operating bands)
A
• Pressing the
A-band and B-band.
• Press and hold the
change the Dual Band Reception mode to the
Mono Band Reception mode.
• While operating the FT-D1 in the Mono Band
Reception mode, press the
A
press the
display.
12
p
switch during transmission.
T
switch to deactivate the
F T
key and switch, turn
v O
key, turn the knob to
P
switch over 1 second to
P
switch over 1 second
switch briefly to lock keys.
key briefly toggles between
A
key over 1 second to
F
key and then
key briefly to enlarge the
i M key
k
• Pressing the
l
modes (frequency
• Press the hold the
m
the Set mode.
n
j Battery pack*
o
k O knob
p
Turn this knob to change frequencies or select a
memory channel.
q
l GPS antenna
r
m MIC/SP jack*
Connect a speaker microphone or earpiece
microphone to this jack.
s
It is not waterproofed when an external
microphone is connected.
Do not connect any product which is not
specified by us. A failure can result.
t
n EXT DC IN jack*
• Connect an external power supply adapter with
a cigarette lighter plug (E-DC-5B) or an external
power cable (E-DC-6) to this jack.
• When charging the battery pack, connect the
battery charger (PA-48) to this jack.
Do not connect any product which is not
specified by us. A failure can result.
o
DATA terminal*
• Use this terminal when using a clone function or
updating the firmware.
• Connect the optional camera-equipped
microphone (MH-85A11U).
• For how to update the firmware, access our
home page.
p Microphone
q Display
This LCD displays reception frequencies and
various settings.
r Speaker
s 15 keys
These keys are used to specify reception/
transmission frequencies and select functions.
t F switch
F
• Press the
keys.
• Press and hold the
write a frequency in the memory.
* When the included antenna and battery pack are
installed and the MIC/SP jack, EXT DC IN jack,
DATA terminal, and micro SD slot are securely
covered with rubber caps, the FT-D1 can deliver
the waterproofing performance conforming to
IPX5 (See page 10).
FCC ID: K6620445X20
IC: 511B-20445X20
M
key switches among display
APRS and GPS).
M
key over 1 second to call
key briefly to activate function
F
key over 1 second to
YAESU MUSEN CO., LTD.