Scanning Area
The scanned area is shown below.
Fax
: 0.1 in. (3.0 mm)
Copy, Scan : 0 in. (0 mm)
Fax
: 0.1 in. (3.0 mm)
Copy, Scan : 0.1 in. (2.0 mm)
Loading Documents in the Automatic Document Feeder (ADF)
1
Place the document face up, and carefully insert the document until the edge
stops in the ADF.
2
Adjust the document guides to the document width.
Note
•
Be sure any correction fluid, ink, or stamps on the document are completely dry
before loading.
•
Remove all metals (staples, paper clips, etc.) before loading documents. Failure to do
so may cause a malfunction.
•
Do not load the document with the document guide extended. The document may be
reduced and printed. Doing so may result in skewed feeding.
•
Do not add or remove documents while they are being scanned.
A document jam may occur.
•
Do not leave too many scanned documents on the document outlet. A document jam
around the outlet may occur.
•
When scanning is complete, remove documents from the document exit tray to avoid
document jams.
Letter
A4
Fax
: Letter 8.4 in. (214 mm)/A4 8.2 in. (208 mm)
Copy, Scan : Letter 8.5 in. (216 mm)/A4 8.3 in.(216 mm)
Scanned area
Loading Documents
1-37
1