Ospfv3 Configuration Examples; Configuring Ospfv3 Areas - HP 4800G Series Configuration Manual

OSPFv3 Configuration Examples

Configuring OSPFv3 Areas

Network requirements
In the following figure, all switches run OSPFv3. The AS is split into three areas, in which, Switch B and
Switch C act as ABRs to forward routing information between areas.
It is required to configure Area 2 as a stub area to reduce LSAs in the area without affecting route
reachability.
Figure 1-2 Network diagram for OSPFv3 area configuration
Configuration procedure
1) Configure IPv6 addresses for interfaces (omitted)
2) Configure OSPFv3 basic functions
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 300
[SwitchA-Vlan-interface300] ospfv3 1 area 1
[SwitchA-Vlan-interface300] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ospfv3 1 area 1
[SwitchA-Vlan-interface200] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ospfv3
[SwitchB-ospf-1] router-id 2.2.2.2
[SwitchB-ospf-1] quit
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ospfv3 1 area 0
[SwitchB-Vlan-interface100] quit
1-16