Mld Snooping Configuration Example; Network Requirements; Configuration Procedure - HP 1920 Gigabit Ethernet Switch Series User Manual

Field
Member Ports

MLD snooping configuration example

Network requirements

As shown in
as the MLD querier.
Perform the configuration so that Host A can receive the IPv6 multicast packets destined for the IPv6
multicast group FF1E::101.
Figure 247 Network diagram
1::1/64
GE1/0/2
Source

Configuration procedure

Configuring Router A
Enable IPv6 multicast routing, assign an IPv6 address to each interface, enable IPv6 PIM-DM on each
interface, and enable MLD on GigabitEthernet 1/0/1. (Details not shown.)
Configuring Switch A
1. Create VLAN 100:
a. Select Network > VLAN from the navigation tree.
b. Click the Create tab.
c. Enter 100 as the VLAN ID.
d. Click Apply.
Description
All member ports.
Figure 247, MLDv1 runs on Router A and MLDv1 snooping runs on Switch A. Router A acts
GE1/0/1
1::2/64 2001::1/64
Router A
MLD querier
Host B
GE1/0/2
GE1/0/1 GE1/0/3
Switch A
274
VLAN 100
Host A
Receiver