Select-In - Compuprint X03 User Manual

4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Parallel Interface
5. Press ENTER.
6. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Parallel Interface
Input Buffer Size
7. Press ENTER to display the current value.
8. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Input Buffer Size is displayed.
9. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
10. Press START or RETURN to exit the Menu. See "Exiting the Configuration
Menu" on page 39.

Select-In

This parameter is valid in Epson-FX emulation mode only and instructs the printer
how to handle Select-In Signals. You can set the Select-In Signal to:
Disabled
Enabled (Default)
To change or check the Select-In Signal:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Parallel Interface
5. Press ENTER.
6. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Parallel Interface

Select-In

7. Press ENTER to display the current value.
8. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Select-In Signal is displayed.
9. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
10. Press START or RETURN to exit the Menu. See "Exiting the Configuration
Menu" on page 39.
The Select-In Signal is ignored and treated as always on.
The printer checks the Select-In Signal from the host.
Chapter 7. ASCII Configuration
87