Return; Park/Path - Compuprint X03 User Manual

RETURN

RETURN function
Pressing RETURN in the Configuration Menu returns to the previous level of the
menu, unless the printer already displays:
If Configuration Menu is displayed, the printer exits the menu and becomes not
ready.
Note: If you have made configuration changes and have not saved them in a

PARK/PATH

PARK function
Pressing this key causes the printer to enter the Park function in either the ready
and not ready state. The continuous forms will back up (reverse the process
direction of) the forms in the forms path.
If continuous forms are currently in the printer and the top of the form is beyond
the print area, press PARK/PATH. The forms will be ejected for tearoff and the
printer will display:
If special forms are currently in the printer that cannot be moved backwards (for
example, labeled continuous forms), the printer displays:
Perform the action requested on the operator panel display. The printer is then
ready for the paper path selection.
PATH function
When no forms are in the current path and the printer is in the not ready state,
pressing PARK/PATH allows the selection of the different forms paths available on
the printer. When the desired path is displayed, press START. The forms path
displayed becomes the active forms path and the printer becomes ready. You can
also press LOAD/EJECT or FORM FEED for continuous forms to select the active
forms path.
32
User's Guide
CONFIGURATION MENU
Configuration Storage
Custom Set, the display will prompt you to save the changes. If you are in
the Operator Print Tests Menu and a test is not running, pressing RETURN
will exit the Test Menu and make the printer not ready.
091 FANFOLD PARK
TEAR OUTPUT PRESS PARK
092 FANFOLD PARK
TEAR INPUT PRESS EJECT