Autofeed-Xt; Serial Interface; Interface Type - Compuprint X03 User Manual

AutoFeed-XT

This parameter is valid in Epson-FX emulation mode only and instructs the printer
whether the host will determine if an automatic line feed is performed after a
carriage return.
You can set this value to:
Disabled
(Default)
Enabled
To change or check the AutoFeed-XT setting, follow these steps:
10. Press START or RETURN to exit the Menu. See "Exiting the Configuration

Serial interface

Interface type

This parameter allows you to select the Serial Interface attachment type. You can
set Interface Type to:
v RS-232C (Default)
To change or check the Interface Type:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
88
User's Guide
The function is determined by the setting of Printer Compatibility 3 –
Automatic Line Feed on Carriage Return.
The host determines whether an automatic line feed is performed after a
carriage return.
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Parallel Interface
5. Press ENTER.
6. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Parallel Interface

AutoFeed-XT

7. Press ENTER to display the current value.
8. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
AutoFeed XT is displayed.
9. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
Menu" on page 39.
CONFIGURATION MENU
ASCII Configuration