Power Connection; Inserting The Power Cable Plug; Power Switch In The I Position (On) - Compuprint X03 User Manual

Power connection

1. Make sure the power outlet is near the printer location and easily accessible.
2. Make sure that the power switch is in 0 position (OFF).
3. Insert the power cable plug into the printer connector and the other power
Figure 15. Inserting the power cable plug
4. Turn the printer on, press the power switch in the I position (ON).
Figure 16. Power switch in the I position (ON).
Attention: If, for any reason, the Controller Board was not correctly installed in
the printer, the printer will not work and the following audio/visual symptoms
will occur:
v The buzzer sounds continuously
v The Operator Panel display is partially filled with solid black boxes
v The Operator Panel LEDs are all lit.
If this is the case, power off the printer, re-seat the Controller Board, and power
the printer on again.
DANGER
<1-11> Your country may require an approved power cord and plug.
Ensure that you have the correct power cord and plug. Use this cord
and plug only with an approved, correctly-installed power receptacle.
cable end into a convenient outlet.
1 2
Chapter 1. Getting started
13