Media Size Priority - Compuprint X03 User Manual

Notes:
1. The printer performs a partial reset to put any change to this parameter value
2. When changing the value of the Emulation Mode, verify the Data Stream and
To change or check the emulation mode, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
7. Press ENTER.
8. Press START or RETURN to exit the Menu. See "Exiting the Configuration

Media Size Priority

This parameter is available only if the IPDS feature is installed, and the IPDS data
stream is selected. It affects the use of the XOH Set Media Size (SMS) order. This
order may be used in the IPDS data stream to set the page size. The Media Size
Priority setting specifies whether XOH-SMS orders take precedence over the
operator panel settings for maximum print position (MPP) and maximum page
length (MPL).
The following values will be displayed in the menu:
Standard
Alternate
(default)
The media size is defined by the MPP and MPL parameters.
To change or check the Media Size Priority, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
into effect when you exit the Configuration Menu with START or RETURN.
Buffered data will be lost.
the Printer Address you have set.
CONFIGURATION MENU
IPDS Configuration
IPDS Configuration
Emulation Mode
Emulation Mode is displayed.
An asterisk (*) will be displayed in front of the selected value.
Menu" on page 39.
The smaller page size values have priority. The page size will be the
intersection (smaller values) of the operator panel settings and the XOH-SMS
X and Y values.
The XOH-SMS order values have priority. If an XOH-SMS order is present,
its values will be used to define the page size instead of the operator panel
settings.
Chapter 6. IPDS Configuration
63