Bar Code Mode - Compuprint X03 User Manual

3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
7. Press ENTER.
8. Press START or RETURN to exit the Menu. See "Exiting the Configuration

Bar Code Mode

This parameter is valid only if the IPDS feature is installed and the IPDS data
stream is selected. Changing the value of this parameter can affect throughput in
some printing environments.
You can set the Bar Code Mode to any of the following values:
High
(Default)
Low
Computer
Selected
Note: The printer performs a partial reset to put any change to this parameter
To change or check the bar code mode, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for bar
7. Press ENTER.
64
User's Guide
CONFIGURATION MENU
IPDS Configuration
IPDS Configuration
Media Size Priority
media size priority is displayed.
An asterisk (*) will be displayed in front of the selected value.
Menu" on page 39.
High Contrast Bar Codes
Low Contrast Bar Codes
Contrast as specified by the IPDS data stream
value into effect when you exit the Configuration Menu with START or
RETURN. Buffered data will be lost.
CONFIGURATION MENU
IPDS Configuration
IPDS Configuration
Bar Code Mode
code mode is displayed
An asterisk (*) will be displayed in front of the selected value.