Automatic Eject; Single Path Usage Recommendations; Dual Path Usage Recommendations - Compuprint X03 User Manual

Table 14. Single Path Usage recommendations
Operation
Single Path
Single Path
Single Path
Single Path
Note: The combination of settings with Automatic Eject = Enabled and Automatic Restore
= Disabled is not recommended.
Table 15. Dual Path Usage recommendations
Operation
Dual Push
Dual Push
Dual Push
Dual Push
Note: The combination of settings with Automatic Eject = Enabled and Automatic Restore
= Disabled is not recommended.

Automatic Eject

This parameter is displayed for the Front Push or Rear Push forms path. You can
set the printer to perform an automatic eject without pressing LOAD/EJECT when
a print job is complete.
You can set this value to:
Enabled
Disabled (Default)
To change or check the automatic eject after timeout, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Setup
Automatic Eject
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for the
Automatic Eject is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
No. Users Tear Off
1 On Demand
1 Constant
2 or more On Demand
2 or more Constant
No. Users Tear Off
1 On Demand
1 Constant
2 or more On Demand
2 or more Constant
When the print job is complete, the printer will
perform an automatic eject after a fixed timeout of
approximately 5 seconds.
No automatic eject. The LOAD/EJECT is required
to eject the forms.
Auto Eject Auto Restore
Disabled Data or Timer
Enabled Data or Timer
Disabled Timer
Enabled Timer
Auto Eject Auto Restore
Disabled Data
Enabled Data
Disabled Data
Enabled Data
Chapter 8. Printer setup
107