Automatic Restore - Compuprint X03 User Manual

8. Press START or RETURN to exit the Menu. See "Exiting the Configuration

Automatic Restore

This parameter is displayed for the Front Push or Rear Push forms path. You can
set the printer to perform an automatic load without pressing LOAD/EJECT.
You can set this value to:
Disabled (Default)
Data
Timer (10 to 50 seconds)
To change or check the automatic restore, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
7. Press ENTER.
8. Press START or RETURN to exit the Menu. See "Exiting the Configuration
The Automatic Restore function can be enabled regardless of the status of the
Automatic Eject function. Automatic Restore can be enabled even if Automatic
Eject is not enabled.
108
User's Guide
Menu" on page 39.
CONFIGURATION MENU
Printer Setup
Printer Setup
Automatic Restore
Automatic Restore is displayed.
An asterisk (*) will be displayed in front of the selected value.
Menu" on page 39.
No automatic load. The LOAD/EJECT is required
to load forms.
An automatic load occurs each time a new print
job is received.
An automatic load with a fixed timeout value.
When forms are ejected, a load function is
performed after a timeout. The timeout value can
be 10 seconds, 20 seconds, 30 seconds, 40 seconds,
or 50 seconds.