Operator Interface Hardware - Oce Arizona 640 GT User Manual

Operator Interface Hardware

Operator Interface Hardware
Introduction
The Operator interacts with printer components to print, maintain, and monitor the state of the
printer. This section identifies and explains the functions of the hardware.
[30] Printer Hardware
Operator Interface Components
Hardware Interface Components
Component
1) Main Power Switch
2) Emergency Stops
3) Carriage Guard
4) Ink Purge Valves
5) Printer Status Beacon
6) UV Lamps
7) Vacuum Gauge
8) Print Button
9) Maintenance Station
38 Chapter 4 - How to Navigate the User Interface
Function
Turns the printer On and Off.
Emergency stop buttons can shut down all motion and hazardous
systems. There are three E-stops, one on the podium stand, and
one on each end of the gantry.
Protects the Operator from exposure to UV light and stops all mo-
tion if dislodged by an obstacle.
Allow the operator to isolate specific printheads to purge ink as
part of cleaning the nozzles.
Indicates printer status. See Chapter 3 for details.
UV light is used to cure the ink.
Displays the strength of the table vacuum system. If it reads less
than 10"Hg, check for vacuum leaks.
Starts the current print job.
Designated area for cleaning the printheads and the underside of
the carriage.
4
Océ Arizona 600 Series