Required Tools; Installing A Supervisor Engine Or A Switching Module - Cisco Catalyst 6500 Series Installation Manual

Required Tools

Warning
Required Tools
Installing a Supervisor Engine or a Switching
Module
Note
Catalyst 6500 Series Switch Module Installation Guide
3-2
During this procedure, wear grounding wrist straps to avoid ESD damage to the
card. Do not directly touch the backplane with your hand or any metal tool, or
you could shock yourself. Statement 93
This section describes the tools that you need to install the supervisor engine or
switching modules.
These tools are required to install switching modules in the chassis:
• Small flat-blade screwdriver
No. 2 Phillips screwdriver
•
Wrist strap or other grounding device
•
Antistatic mat or antistatic foam
•
Before installing switching modules, you must install the switch chassis and at
least one supervisor engine. For information on installing the switch chassis, refer
to the Catalyst 6000 Series Switch Installation Guide or the Catalyst 6500 Series
Switch Installation Guide.
This section describes how to install a supervisor engine in the chassis. Supervisor
engines must be installed in specific slots in the chassis depending on which
model of supervisor engine you are installing.
assignments for the different supervisor engine models.
Chapter 3 Installing the Module
Table 3-1 lists the specific slot
78-15725-02