Table of Contents
Advertisement
Connect Switch to the Network
Required Tools and Equipment
You need these tools to install the transceiver modules:
• Wrist strap or other personal grounding device to prevent ESD occurrences.
• Antistatic mat or antistatic foam to set the transceiver on.
• Fiber-optic end-face cleaning tools and inspection equipment.
Installing the Transceiver Module
Caution
Caution
The QSFP transceiver module has a pull-tab latch. To install a transceiver module, follow these steps:
Procedure
Step 1
Attach an ESD wrist strap to yourself and a properly grounded point on the chassis or the rack.
Step 2
Remove the transceiver module from its protective packaging.
Step 3
Check the label on the transceiver module body to verify that you have the correct model for your network.
Do not remove the dust plug until you're ready to attach the network interface cable. Dust plug is not shown
in the images.
Step 4
Hold the transceiver by the pull-tab so that the identifier label is on the top.
Step 5
Align the transceiver module in front of the module's transceiver socket opening and carefully slide the
transceiver into the socket until the transceiver contact with the socket electrical connector.
The transceiver module is a static-sensitive device. Always use an ESD wrist strap or similar individual
grounding device when handling transceiver modules or coming into contact with system modules.
Protect the transceiver ports by inserting clean dust caps (NXA-ACC-QDD-DC) into any ports not in use. Be
sure to clean the optic surfaces of the fiber cables before you plug them back into the optical ports of another
module. Use dust caps for all the open ports on the chassis.
The switch ships with dust caps plugged in. We highly recommend you to keep the dust caps plugged in until
you are ready to plug an optic.
The dust caps protect the ports from possible EMI interference and also avoid contamination due to dust
collection. To meet the EMI interference requirements, you must use the metal dust caps when the ports are
not in use by optical modules.
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
Required Tools and Equipment
55
Advertisement
Table of Contents
