Location Training For Stationary Devices - Dell PowerConnect W-Airwave User Manual

Left-click and hold at the begin point of the wall
2.
Move the cursor to the end point of the wall
3.
Release the left mouse button
4.
Figure 23. "Draw a wall"
To toggle off wall drawing tool click on the Wall icon in the Floor Edit Tools section.
5.
To move or resize the wall grab one of the end point handles (black squares with green borders).
6.
To change the attenuation of a wall left-click on the wall and select the appropriate building
7.
material.
To delete a wall left-click on the wall and select the "Delete Wall" option.
8.
Once all walls are provisioned on the floor plan click the Save button (floppy disk) at the bottom
9.
right of the page.
A Save Changes dialogue box will appear.
10.
Click the OK button to commit the change.
11.
A Changes Saved dialogue box will appear
12.
Click the OK button to continue
13.
Note: Dell recommends only drawing outside walls. If you are seeing inaccurate client locations or
heat maps after entering exterior walls, proceed to Client Surveys. If you still experience problems,
then you can proceed to adding interior walls.

Location Training for Stationary Devices

QuickView provides the ability to statically assign a permanent x, y coordinate to stationary devices like
PCs, Scales, and Point-of-Sale terminals. This will reduce the calculation requirements on the VisualRF
location service and increase the accuracy of the RF characteristics of individual floor plans.
Left-click and hold client device that you want to utilize for the survey.
1.
Move to proper location and release left mouse button. A popup menu will open.
2.
Select Surveys and Training option
3.
Click the "Add" button for Static Training
4.
Note: The static locations are automatically saved, so the save button (floppy disk) will not appear.
28 Visual RF an d Visual RF Plan | User Guide