Dell PowerConnect B-RX Configuration Manual page 49

Bigiron rx series supporting multi-service ironware v02.7.03
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

TABLE 6
Enhancement
VSRP Fast Start
LACP Enhancements
Multicast Layer 2 Filter
Layer 3 features
IPv6 PIM-SM
IPv6 Embedded RP
IPv4 PIM Snooping
Multicast Listening Discovery
(MLD)
BigIron RX Series Configuration Guide
53-1001986-01
Summary of enhancements in release 02.6.00 (Continued)
Description
Non-Brocade or non-VSRP aware devices
connected to a VSRP master can now quickly switch
over to the new master when a VSRP failover
occurs.
Beginning with release 02.6.00 of the Multi-Service
IronWare software, all trunking and link aggegation
configuration has been revamped and placed under
a single interface. This new interface allows you to
configure either of the previously supported LAG
types: Static LAGs and Dynamic LAGs as well as the
new "Keep Alive" LAGs.
The new LAG configuration procedures supersede
the previous configurations procedures for Trunks
and Dynamic Link Aggregation.
Beginning with release 02.6.00, you can define
multicast boundaries on a per VLAN basis.
In Release 02.6.00 of the Multi-Service IronWare
software, the BigIron RX supports IPv6 Protocol
Independent Multicast (PIM) Sparse. IPv6 PIM
Sparse provides multicasting that is especially
suitable for widely distributed multicast
environments
This release supports Embedded RP which allows
the switch to learn RP information using the
multicast group destination address instead of the
statically configured RP.
PIM SM traffic snooping eliminates the superfluous
traffic by configuring the device to forward IP
multicast group traffic only on the ports that are
attached to receivers for the group
Release 02.6.00 adds support for MLD Snooping
(MLDv1 and MLDv2) on Brocade BigIron RXdevices
running IPv6.
See page
Book: BigIron RX Series
Configuration Guide
Chapter:
"Virtual Switch
Redundancy Protocol
(VSRP)"
Section:
"VSRP fast start"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Link
Aggregation"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Configuring IP
Multicast Protocols"
Section:
"Layer 2 multicast
filters"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Configuring IPv6
Multicast Features"
Section:
"IPv6 PIM-sparse
mode"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Configuring IPv6
Multicast Features"
Section:
"Embedded
Rendezvous Point (RP)"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Configuring IP
Multicast Protocols"
Section:
"PIM SM traffic
snooping"
Book: BigIron RX Series
Configuration Guide
Chapter:
"Configuring IPv6
Multicast Features"
Section:
"Multicast
Listener Discovery and
source specific multicast
protocols (MLDv2)"
xlix

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents