Dell PowerConnect B-RX Configuration Manual page 68

Bigiron rx series supporting multi-service ironware v02.7.03
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

Enhancements in release 02.2.00
TABLE 26
Enhancement
Quality of Service (QoS)
Support
Rate-limiting Support
Hardware Forwarding of
Packets
Switching and Routing
Packets
No Support for Core
Device to Copy the QoS
Priority
Trunk Support
Multicast Entry Limit
WAN PHY Mode Support
For further information about new features and documentation updates for this release, refer to
the Knowledge Portal at kp.foundrynet.com.
lxviii
Summary of emhancements in 02.2.00
Description
QoS support on the BigIron RX is different than for the
BigIron MG8.
Rate-limiting can be performed based on ACL matching of
flows and L2/L3 priority. It operates as on the BigIron
MG8 except:
Only Inbound rate limiting is supported.
802.1p packet priority is used by default
Rate limit accounting is available if WRED is not
enabled.
CLI changes required for these differences are described
in the page referenced on the next column.
Default behavior on BigIron RX is hardware unknown
unicast and multicast flooding.
Operation of packet switching and routing have changed
with the BigIron RX. Details are described in the page
referenced on the next column.
This feature is not supported on BigIron RX.
On the BigIron RX, the switch, server, and per-packet
options for trunking are not supported.
1542 multicast entries are limited to IPv4 1542 entries
provided every group has only one destination.
This release supports WAN PHY Mode per 10 GB Ethernet
port.
See page
Book: BigIron RX Series
Configuration Guide
Chapter:"Configuring
Quality of Service"
Book: BigIron RX Series
Configuration Guide
Chapter:"Configuring
Traffic Reduction"
Book: BigIron RX Series
Configuration Guide
Chapter:"VLANs"
Section:"Hardware
flooding for Layer 2
multicast and broadcast
packets"
Book: BigIron RX Series
Configuration Guide
Chapter:"VLANs"
Section:"Unknown
unicast flooding on VLAN
ports"
N/A
N/A
N/A
Book: BigIron RX Series
Configuration Guide
Chapter:"Configuring
Interface Parameters"
Section:"Enabling WAN
PHY mode support"
BigIron RX Series Configuration Guide
53-1001986-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents