Dell PowerConnect B-RX Configuration Manual page 42

TABLE 1
Category
Management Options
Security
CPU protection
SysLogD Server Logging
sFlow
Uni-directional Link Detection (UDLD)
Layer 2 features
802.1d
802.1p
802.1q
802.1s
802.1w
802.3ad
Jumbo packets
Layer 2 Hitless failover
Layer 2 IGMP Snooping
L2 ACL
MAC Filtering
MRP
PVST / PVST+
xlii
Supported features (Continued)
Feature description
Serial and Telnet access to industry-standard Command Line
Interface (CLI)
SSHv2
TFTP
Web-based GUI
SNMP versions 1, 2, and 3
IronView Network Manager .
AAA Authentication
Local passwords
RADIUS
Secure Shell (SSH) version 2
Secure Copy (SCP)
TACACS and TACACS+
User accounts
802.1x: All EAP types, including MD5, TLS, TTLS, and PEAP
Multi-device port authentication
AES for SNMPv3, SSHv2, SCP, and HTTPS
Note:Telnet, SSH, Web and SNMP servers are disabled by default,
and can be enabled selectively.
There are no CLI commands for CPU protection. The device forwards
unknown unicast, broadcast and multicast packets in hardware;
therefore, the CPU is automatically 'protected' from having to handle
too many packets.
Multiple SysLogD server logging
sFLow version 5
Monitors a link between two Brocade devices and brings the ports on
both ends of the link down if the link goes down at any point between
the two devices.
Spanning Tree Protocol (STP)
and
Single Spanning Tree Protocol (SSTP)
Quality of Service (QoS) queue mapping
See VLANs, below
Multiple Spanning Tree Protocol (MSTP)
Rapid Spanning Tree Protocol (RSTP)
Dynamic Link Aggregation on tagged and untagged trunks
Layer 2 jumbo packet support
Filtering based on MAC layer-2 parameters.
MAC filtering and address-lock filters to enhance network security
Metro Ring Protocol (MRP) Phase 1 and 2
Per-VLAN Spanning Tree (PVST)
BigIron RX Series Configuration Guide
53-1001986-01