About Transition Effects - Barco ImagePRO-II User Manual

4. Menu Orientation
^Äçìí=qê~åëáíáçå=bÑÑÉÅíë
The ImagePRO-II supports three transition effects that occur when you switch between
inputs:
•
•
•
For the Black Fade and Logo modes, you can set the transition time within a range of 1.0
to 5.0 seconds.
These timings apply only when In Auto Acquire is turned Off. With In Auto Acquire
turned On, the transition time is slightly greater because of the time required to analyze the
input video timing.
The following figure shows the transition from a video to a logo still frame.
Input
Figure 4-60. Transitioning to a Logo
The following figure shows the transition from one video through a logo to a second video.
Input 1
Figure 4-61. Transitioning through a Logo to a Second Input
There are two options on the Transition Menu, as shown in the following figure. The first
sets the transition type, and the second sets the timing of the transition for Black Fade and
Logo transitions.
ImagePRO-II • User's Guide
A confirmation message appears. The custom settings assigned to the view are
deleted, and the view is restored to its default values. The preset name of the view
remains in the system.
Black Fade — The selected input's video fades to black, then the video
transitions to a new input, in a pre-selected timeframe.
Image Cut — The selected input's video freezes, then the new input's video is
acquired and cuts to the output display.
Logo — This option is only available when the ImagePRO-II has a stored logo
image. The selected input's video dissolves to the logo image, then the new
input's video dissolves in from the logo, in a pre-selected timeframe.
For information about capturing a logo, refer to
on page 89.
Transition Time
Using a Logo or Internal Black
LOGO
LOGO
Transition Time

About Transition Effects

Input 2
75