Barco ImagePRO-II User Manual page 162

B. Remote Control Protocol
Introduction
fåíêçÇìÅíáçå
This chapter lists and provides details for the ImagePRO-II remote control commands. You
can view these commands online by accessing the ImagePRO-II via a telnet connection to
the unit's IP address. The ImagePRO-II default IP address is 192.168.0.201.

To access the ImagePRO-II's remote commands, use the following procedure:
1.
2.
3.
You can copy the command list and the details of any commands, then paste them into a
text file for future reference.
148
In a command prompt window, type a telnet command in the following format:
telnet nnn.nnn.nnn.nnn 10001
where the n's represent the ImagePRO-II's IP address and 10001 is the port.
Then press Enter.
At the command prompt, type help and press Enter.
Two lists of ImagePRO-II commands appear. The first list is the current
ImagePRO-II command list. The second list contains legacy commands that have
been carried over from the ImagePRO.
To see the specifics of a particular command, type:
<command name> --help

Example: enet --help
ImagePRO-II • User's Guide