Barco ImagePRO-II User Manual page 34

3. Hardware Installation
Installation
fåëí~ää~íáçå=oÉèìáêÉãÉåíë
To set up the ImagePRO-II, you will need the following equipment:
Table 3-2. Equipment List, Basic ImagePRO-II System
Qty. Item
1 ImagePRO-II unit
1 Display device
1 Ethernet Switch
1 Ethernet cable
1 Video cable
TBD Dedicated sources
When connecting to an ImagePRO-II, use high-quality shielded cables.
If you intend to operate the ImagePRO-II remotely using the Web Interface, you can do so
over a wireless network. For this option, you will need a wireless router and access to a
wireless network, along with a device such as a smartphone, computer or laptop, notebook
or tablet.
fåëí~ääáåÖ=íÜÉ=fã~ÖÉmolJff

Use the following procedure to install the ImagePRO-II:
1.
2.
3.
4.
5.
6.
20
Chapter 4, or by using zoom and pan settings, as described in
on page 71 in Chapter 4.
Customer supplied
Customer supplied (Optional: for web interface, Encore Controller, or
ScreenPRO-II Controller)
Customer supplied
Customer supplied (Optional, for Genlock and Genlock Loop)
Analog and/or digital video as required (customer supplied)
Follow the unpacking procedures as listed in the
section on page 16.
As required, refer to the
Physical and Electrical Specifications
page 135 in Appendix A for electrical and mechanical details.
As required, refer to the
ImagePRO-II Rear Panel
Chapter 2 for the locations of all connectors.
If you are rack mounting the ImagePRO-II chassis, follow the rack mount
procedures as outlined in the
Ethernet Connections
Connect an Ethernet cable to a Switch.
a.
Ensure that the Switch is connected to a data port.
b.
Connect the Ethernet Switch to the ImagePRO-II's Ethernet port.
c.
As an alternate method, you can use a direct Ethernet
Note
connection or a wireless connection between the
ImagePRO-II and a web-enabled device.
Source Connections
Note
Unpacking and Inspection
section on page 12 in
Rack-Mount Installation
ImagePRO-II • User's Guide
Creating a View
section on
section on page 16.