Barco ImagePRO-II User Manual page 183

Figure C-1. Format Removable Disk Window
6.
7.
mÉêÑçêãáåÖ=íÜÉ=cáêãï~êÉ=réÖê~ÇÉ=rëáåÖ=íÜÉ=rp_=mçêí

To upgrade the ImagePRO-II firmware via the USB port, use the following procedure:
1.
2.
3.
ImagePRO-II • User's Guide
Then click Start. A message appears, warning that data will be erased during the
formatting process.
~ Click OK to continue.
~ Click Cancel to halt the process.
If you click OK, a confirmation message appears after a few seconds. The flash
drive is now ready to use.
If you click Cancel, you can delete data or download it to the computer, then retry
the formatting operation.
Insert the flash drive into the ImagePRO-II's USB port.
Select Firmware Upgrade from the Setup Menu. The Firmware Upgrade
Submenu appears.
F I R M W A R E U P G R A D E
> U S B U p g r a d e
W e b U p g r a d e
Figure C-2. Code Upgrade Submenu
Select USB Code Upgrade. The menu shown in the following illustration appears.
U S B F I R M W A R E U P G R A D E
> I m a g e P R O 2 _ 1 0 _ 5 . t a r . g z
U p g r a d e
( F A T f i l e s y s t e m o n l y )
Figure C-3. USB Code Upgrade Menu
`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the USB Port
> >
> >
169