Barco ImagePRO-II User Manual page 182

`K==réÖê~ÇáåÖ=cáêãï~êÉ
Firmware Upgrade Overview
cáêãï~êÉ=réÖê~ÇÉ=lîÉêîáÉï
The ImagePRO-II provides two options for upgrading firmware:
•
•
réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=rp_=mçêí
First, ensure that your flash drive is formatted to use the FAT32 file system. If necessary,
reformat the drive as described in the following section. When the drive is properly
formatted, refer to
for the upgrade procedure.
cçêã~ííáåÖ=íÜÉ=cä~ëÜ=aêáîÉ
Ensure that the drive contains no data.

Then use the following procedure to format the flash drive:
1.
2.
3.
4.
5.
168
Using the USB port on the front panel. For instructions, refer to
Firmware Using the USB Port
To use this option, your flash drive must be properly formatted. For instructions,
refer to
Formatting the Flash Drive
Using the Web Interface. For instructions, refer to
on page 170 of this chapter.
the Web Interface
Performing the Firmware Upgrade Using the USB Port
Reformatting the flash drive erases existing data. To avoid
losing data, download to a computer or a secure site any files
you wish to keep, then format the drive.
Insert the flash drive into a Windows PC or laptop's USB port.
Select Start > My Computer.
On the My Computer screen, right-click the drive that represents the flash drive.
Select Format from the menu that appears. The Format Removable Disk screen
appears.
Select FAT32 as the file system, and Quick Format under Format Options, as
shown in the following illustration.
on this page.
on this page.
Upgrading Firmware Using
ImagePRO-II • User's Guide
Upgrading
on page 169