Barco ImagePRO-II User Manual page 133

5. Web Remote Control Operations
3.
4.
j~ëâáåÖ=~å=fã~ÖÉ=ïáíÜ=íÜÉ=tÉÄ=^éé=fåíÉêÑ~ÅÉ
In the Mask section of the Input Sizing Adjust page, you can mask each edge separately.
Masking an image means applying black bars to one or more edges, typically to remove
noise. Mask values are given in percentages, and range from 0% to 100%. The default
mask value is 0%.

To mask the image on display, change the values for one or more edges, either by
moving the slider to the right from 0, or by typing a percentage value in the field to the
left of the slider.
If you wish to mask all the edges at once to achieve a particular aspect ratio, you can do so
from the front panel. Refer to the
p~îáåÖ=~åÇ=oÉëÉííáåÖ=fåéìí=`çåÑáÖìê~íáçåë
After changing an input's settings, you can save those settings on the Input Config page.
On this page, you can also restore the input's default configuration after making changes.
Figure 5-21. The Input Config Page

To save an input's custom configuration settings, use the following procedure:
1.
2.
3.

To restore the input to its default configuration, select the input and click Reset Config.
ImagePRO-II • User's Guide
Select H Pos to pan an image left or right, within the active area. Values are in
pixels. The default value is 0, representing the horizontal center of the active area.
Decreasing the H Pos value moves the image to the right. Increasing the H Pos
value moves the image to the left.
Select V Pos to pan an image up or down, within the active area. Values are in
lines. The default value is 0, representing the vertical center of the active area.
Decreasing the V Pos value moves the image up. Increasing the V Pos value
moves the image down.
Using Mask Presets
With the input selected, navigate to Input > Input Config.
Click the filename field beside the Save Config button. Type a filename.
The filename can consist of up to 20 alphanumeric characters. If you include
spaces or special characters — such as asterisks, percentage signs or
ampersands — the field background turns red and you cannot save the name.
Click Save Config. A confirmation message appears.
Configuring Inputs with the Web App Interface
section of Chapter 4, on page 39.
119