Barco ImagePRO-II User Manual page 95

4. Menu Orientation
The following illustration shows the USB Backup/Restore Submenu, which you access
from the System Menu.
USB BACKUP/RESTORE
> USB Detected
Backup Config
Restore Config
Backup Logo
Restore Logo
Figure 4-67. USB Submenu
Using this menu, you can:
•
•
•
_~ÅâáåÖ=ré=`çåÑáÖìê~íáçå=cáäÉë

To back up a configuration file to a flash drive, use the following procedure:
1.
2.
3.
4.
ImagePRO-II • User's Guide
Detect the presence of a USB device.
Back up and restore ImagePRO-II configuration files. When you connect a flash
drive to the ImagePRO-II, the ImagePRO-II creates a directory titled
ImagePRO2Backup on the drive. All logo images and configuration files are
saved to this directory.
Download and restore a logo image from another ImagePRO-II.
Insert a formatted flash drive in the ImagePRO-II's front-panel USB port.
From the System Menu, scroll to the USB Backup/Restore Submenu. Select
Backup Config.
The USB Backup Config Submenu appears, as shown in the following
illustration. The navigation cursor appears at the default name for the first backup
file.
U S B B A C K U P C O N FIG
> S ysB ackup1
B ackup C onfig
(FA T filesystem only)
Figure 4-68. USB Backup Config Submenu
If you wish to change the default name of the backup configuration, press SEL.
Use the ADJUST knob to change the name, as described in
on page 45. Press SEL again when you complete the name
Configuration
change.
Scroll to Backup Config and press SEL.
A confirmation message appears when the backup is complete.
If the backup operation fails, the message shown in the following illustration
appears. Check that the flash drive is properly formatted and installed, and try
again.
Using the System Menu
No
>>
>>
>>
>>
Saving an Input
81