Barco ImagePRO-II User Manual page 185

^ìíçã~íáÅ~ääó=réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=tÉÄ=
fåíÉêÑ~ÅÉ

Use the following procedure to automatically upgrade ImagePRO-II software with the
Web Interface:
1.
2.
pÉäÉÅíáåÖ=~=cáêãï~êÉ=cáäÉ=íç=réäç~Ç=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ

Use the following procedure to select a firmware version to install using the Web
Interface:
1.
2.
3.
4.
ImagePRO-II • User's Guide
Open a compatible web browser, and enter the ImagePRO-II's IP address in the
address bar. The web page shown in the following illustration appears.
Figure C-5. System Information Tab
This page provides information about the current firmware version. In addition,
there are two options:
~
Auto Upgrade
~
Upload Firmware
To detect and upload new firmware automatically, click Auto Upgrade.
If a new firmware version is available, it loads and a confirmation message
appears. This process may take several seconds.
On the System Information tab, click Upload Firmware.
The System Firmware Upgrade window appears.
Click Choose File.
On the window that appears, navigate to and select the firmware file you want to
upload.
On the System Firmware Upgrade window, click Submit.
`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the Web Interface
171