Selecting A Firmware File To Upload With The Web Interface - Barco ImagePRO-II User Manual

`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the Web Interface
4.
5.
réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ=
Before you begin the firmware upgrade, ensure that your PC, laptop, or mobile device uses
one of the following operating systems:
•
•
•
You must also know the IP address of your ImagePRO-II unit, which you can find by
selecting Setup > System > Ethernet.
`ÜÉÅâáåÖ=Ñçê=^î~áä~ÄäÉ=cáêãï~êÉ=réÖê~ÇÉë

To determine whether a new version of the ImagePRO-II firmware is available, use the
following procedure:
1.
2.
3.
170
Scroll to the file you want to use, and press SEL.
Scroll to Upgrade and press SEL again.
A progress message appears.
Do not remove the flash drive or power down the
Note
ImagePRO-II until the firmware file is uploaded.
When the file is loaded, the ImagePRO-II powers down and reboots.
® ®
Windows XP, Windows
®
Mac OS X
® ®
Red Hat Linux
Verify that the ImagePRO-II has internet access. Contact your system
administrator if necessary.
Select Setup > Firmware Upgrade > Web Upgrade. The submenu shown in the
following illustration appears.
W E B F I R M W A R E U P G R A D E
> C h e c k
V e r i f y i n t e r n e t a c c e s s
b e f o r e c o n t i n u i n g .
Figure C-4. Web Firmware Upgrade Submenu
Select Check.
A message informs you if a new firmware version is available. To install the latest
version over the internet, refer to the following section,
Firmware Using the Web
If you wish to install a different version, refer to the section of this chapter titled

Selecting a Firmware File to Upload with the Web Interface

If you are not connected to the internet, a message prompts you to check the
connection.
®
Vista™, or Windows 7
> >
Interface.
ImagePRO-II • User's Guide
Automatically Upgrading
on page 171.