Barco ImagePRO-II User Manual page 115

5. Web Remote Control Operations
^ÅÅÉëëáåÖ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ

To access the Web Interface, you can connect an ImagePRO-II directly to a computer
or mobile device, using a wireless network or a cable, or use an optional Ethernet
Switch as described in the following procedure.
1.
2.
3.
4.
5.
6.
7.
lÄí~áåáåÖ=póëíÉã=fåÑçêã~íáçå=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ
The System Information tab, shown in the following illustration, is the first page you see
when you access the ImagePRO-II from the web.
ImagePRO-II • User's Guide
On the ImagePRO-II's rear panel, ensure that the Ethernet port is connected to an
Ethernet Switch, and the Switch is connected to a data port.
Connect the Switch to the computer or mobile device from which you want to run
the ImagePRO-II.
Connect inputs and outputs to the ImagePRO-II. For details, refer to the
section of Chapter 3,
Installation
Power up the ImagePRO-II.
Power up the input source and output display devices.
Turn on the ImagePRO-II's DHCP setting:
~ On the Setup Menu, select System > Ethernet.
~ Select DHCP and turn it On.
On the computer or mobile device, open a browser and type the ImagePRO-II's IP
address in the following format:
nnn.nnn.nnn.nnn
The Folsom ImagePRO-II page appears on the display device(s), with the
System Information tab available.
Figure 5-1. System Information Tab
Obtaining System Information with the Web Interface
Installation, on page 19.
Hardware
Firmware Version
Available Upgrade
Upgrade to Latest Version
Upload Another Version
FPGA Temperature
101