Barco ImagePRO-II User Manual page 39

4. Menu Orientation
nìáÅâ=pÉíìé=~åÇ=léÉê~íáçå
To quickly set up and begin operating your system, follow the steps in this section. Links
are provided to the appropriate sections in this guide, if you require more information.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Position the image — From a single convenient menu, you can quickly place the
11. Set and adjust inputs — As required, select an input and adjust color balance,
12. Save input configuration — After completing all adjustments for an input, save
13. Repeat for each input — Repeat the previous two steps for each input
14. Adjust system parameters — As required, adjust system parameters such as
ImagePRO-II • User's Guide
Connect power — Ensure that power is properly connected to the ImagePRO-II.
(Chapter 3, Installation, page 19.)
Connect inputs — Connect all input sources to the ImagePRO-II. (Chapter 3,
Installation, page 19.)
Connect outputs — Connect the output(s) on the ImagePRO-II to your
projector(s) or other target devices. (Chapter 3, Installation, page 19.)
Turn on power — Turn on power to the ImagePRO-II, your projector(s), and to all
peripheral equipment. (This chapter,
Factory reset — If you are using the ImagePRO-II for the first time, or if you are
using an ImagePRO-II that has just returned from another event, perform a full
factory reset to restore default system configurations. (This chapter,
Settings, page 96.)
Factory Default
Read the output format — If the primary output is connected to an HDMI, DVI-D,
HD-15 or DisplayPort connector, obtain the output's preferred resolution and
frame rate. This is the format the ImagePRO-II uses. (This chapter,
Config, page 50.)
Auto
Adjust output format — If the primary output is connected to the composite
video connector or the SDI connector, you can adjust the output format manually if
necessary. (This chapter,
Test output — Turn on a test pattern, verify that you have an image, and make
any necessary adjustments. When complete, turn off the test pattern. (This
chapter,
Working with Test
Save output configuration — After completing output adjustments, save the
output configuration. (This chapter,
image where you want it on the output display device, then scale it up or down,
and apply masks if necessary. Then you can save your changes and press an
input button to begin your presentation. (This chapter,
page 94.)
The preceding step provides a reliable shortcut when your
Note
setup does not require complex adjustments. Use this step
instead of or in conjunction with steps 11 through 13.
timings, and any other settings necessary. (This chapter,
page 33.)
the input configuration. (This chapter,
connected to the ImagePRO-II.
ImagePRO-II display brightness and HDCP settings. (This chapter,
Menu, page 77.)
System
Initialization, page 24.)
Power-Up
Format, page 50.)
Setting the Output
Patterns, page 63.)
Saving an Output
Saving an Input
Quick Setup and Operation
Restoring
Using EDID
Configuration, page 63.)
Setting up an LED Wall,
Configuring Inputs,
Configuration, page 45.)
Using the
25