Barco ImagePRO-II User Manual page 67

4. Menu Orientation
To adjust the Area of Interest, you use four settings on the Area of Interest Submenu,
shown in the following illustration. You can also restore the default AOI.
AREA OF INTEREST
> H Size
V Size
H Pos
V Pos
Reset
Figure 4-26. Area of Interest Submenu (sample)
•
•
•
ImagePRO-II • User's Guide
H Size — Determines the width (in pixels) of the Area of Interest. This setting
must be equal to or less than the H Active setting of the output timing. The
following illustration shows an image after adjusting only the H Size.
Figure 4-27. H Size Adjustment
V Size — Determines the height (in lines) of the Area of Interest. This setting must
be equal to or less than the V Active setting of the output timing. The following
illustration shows an image after adjusting only the V Size.
Figure 4-28. V Size Adjustment
H Pos — Using H Pos, you can move the image horizontally. The default value is
0, representing the left edge of the active area. Increasing the H Pos value moves
the image to the right. Decreasing the H Pos value moves the image to the left.
You can adjust H Pos only after adjusting H Size.
Configuring Outputs
850
1080
0
0
53