Barco ImagePRO-II User Manual page 56

4. Menu Orientation
Configuring Inputs
•
•
•
•
•
•
When 1:1 Sample is Off, the Timing Adjust Submenu changes to the Edge Timing
Adjust Submenu. For more information, refer to the
this page.
^ÇàìëíáåÖ=bÇÖÉ=qáãáåÖë
When the 1:1 Sample option is Off, the Edge Timing Adjust Submenu is available in
place of the Timing Adjust Submenu.
EDGE TIMING ADJUST
> Right Edge
Left Edge
Top Edge
Bottom Edge
Figure 4-12. Edge Timing Adjust Submenu (sample)
Using this menu, you can set the exact locations of the active video edges, when 1:1
Sample is Off. For the right and left edges, the values are in pixels, and the position is
relative to the start of H Sync. For the top and bottom edges, the values are in numbers of
lines, relative to the start of V Sync.
Because 1:1 Sample is off, the image is oversampled, and the image quality may be lower
than when 1:1 Sample is turned on.
pÉííáåÖ=fåéìí=`çåíê~ëí=~åÇ=_êáÖÜíåÉëë
From the Input Menu, select Contrast to change the contrast of the selected input. Select
Brightness to change the brightness.
For both Contrast and Brightness, the adjustment range is in percentages, from 25% to
150%. The default setting for both parameters is 100%. Use the ADJUST knob to scroll
through the range, and press SEL to select a value.
42
If the Sample Phase is n/a, then either 1:1 Sample is Off, or the input is not
analog YP P or RGB.
b r
H Total — This value is the total pixel count per line. This value cannot be
adjusted on the DVI-I or SDI connectors (Inputs 1 and 5).
H Position — Sets the offset of the start of the active area from H Sync.
H Active — Sets the size of the active area.
V Total — Displays the total line count per frame. This value cannot be changed
for any input.
V Position — Sets the offset of the start of the active area from V Sync.
V Active — Sets the size of the active area.
When making active area adjustments, turn on the Output
Note
Raster Box, and align the input image with all four edges of
the box. To turn on the raster box, refer to the
Test Patterns
Adjusting Edge Timings
2460
592
85
803
section on page 63.
ImagePRO-II • User's Guide
section on
Working with